GPS Controls OSSIMPlanet

Two wires to hook an eTrex data cable up to the Arduino

With OSSIMPlanet’s nifty camera control and listener functionality, as demonstrated in my last post, you’ve got so many neat opportunities. A couple nights ago I got a basic GPS NMEA parser working. Here’s a pic of the ultra-professional connection method I use to hook it to my arduino boardÂ đŸ™‚

Two wires to hook an eTrex data cable up to the Arduino
Two wires to hook an eTrex data cable up to the Arduino

Oops, just realised that the picture shows the wires in the wrong spot (it was a late night photo). Pin 2 from the serial cable goes into the Power GND on left side of board. Pin 5 from serial cable goes into the Digital Pin 0 aka RX pin on lower right.

Note that I had a lot of confusion regarding the pin-out options for the Etrex. I looked at several diagrams and couldn’t get the right pins to work. It appears that you may actually need to swap the ground/TX pins to make it work – that’s what I had to do. This is something to do with how the serial connection works.. something I won’t pretend to understand – but swapping the wires worked, that’s all I know!

Of course you could always use your nifty new bluetooth GPS receiver, or plug your receiver directly into the PC and this would still work. But for me, I will have additional devices going into the arduino, where their signals will get mixed together before being sent to the PC.

Arduino setup

The arduino doesn’t do much here, except filter the strings coming from the GPS. It grabs only the $GPGGA string that has the location info I want. I specifically used the GPGGA because the Python NME parser code example I had used that one and I didn’t want to have to learn how to handle the $GPRMC strings.

Here’s the basic code I run on the Arduino:


I had originally hoped to do the XML prep in the arduino, but skipped it for now due to my poor understanding of variable types in the processing language. So for now I’ve still got a lot of cruft leftover in the above, that I didn’t need from the original tutorial code. But as I add more sensors I’ll want to do more mixing in the board itself.

So the arduino board just sends a raw NMEA $GPGGA string to the serial port, where Python takes over.

Python Serial Reader and OSSIM Controller

I then use a Python script that checks for strings coming from the arduino board. It does a bit of filtering, but not much error checking at the moment. This is the first time I’ve used Python to connect to the serial port, so it was fun to learn and so simple!

I found this GPGGA parser code and incorporated it into my script. I won’t paste it here as it is quite long. But here is the rest of my script – reading from Serial, parsing results, then reformatting and sending to OSSIMPlanet… comments, cruft and crummy coding.. all yours for free!

Be sure to have OSSIMPlanet running and set its Preferences to listen on port 5000 first.

That’s about it. In OSSIMPlanet the updates are practically instantaneous, but I wait 1 sec for new GPS data to come in. When I start using the nunchuks I’ll want to do more updates faster to emulate the movement smoother. But that’s for another day…

© Tyler Mitchell /